UTC TruVision IP Dome Manual de usuario descargar pdf (Pagina 35)

3BChapter 4: Configuring the camera

TruVision IP Dome Open-Standards User Manual 31

To set up an alarm relay output:

1. In the “Alarm Parameters” folder open the Alarm Output screen.

2. Select one of the alarm outputs from the Alarm output drop-down list, A1 or

A2.

3. Select the alarm output delay time.

The alarm output delay is the length of time during which the relay is

operational after the alarm occurs. Select a Delay option: 5, 10, and 30

seconds, 1, 2, 5, and 10 minutes, and Manual stop. If “Manual stop” is

selected the alarm output will stop only when the alarm input stops.

4. Click Save to save changes.

Note: The camera will prompt you to reboot in order for the schedule changes

to take effect.

Events scheduling

Use the deployment time menu to schedule when events can be registered. It

specifies when the alarm inputs and outputs as well as motion detection are

operational. Outside of these scheduled periods the system cannot register any

events. You can configure up to four event periods a day.

For the event schedule to be operational, you must also define the motion

detection parameters (see page 35) as well as the alarm input and output

parameters (see page 30.) The recording schedule for motion detection must fall

within the time period of the event schedule.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 65 66

Sin comentarios

UTC TruVision IP Dome Manual de usuario Pagina 35