UTC TruVision IP Dome Manual de usuario descargar pdf (Pagina 14)

1BChapter 2: Installation

10 TruVision IP Dome Open-Standards User Manual

4. If needed, seal all mounting holes so that no moisture can leak into the

mounting surface.

5. Insert the fixation pins of the dome camera housing into the fixation slots in

the mounting plate (1).

6. Rotate the camera enclosure (2) so that the pins are held in place in the

fixation slots.

7. Tighten the locking screw (3) to ensure that the camera is firmly attached to

the bracket.

8. Using the supplied hex wrench, loosen the two fixed screws in the camera

cover and remove the cover.

9. Connect the supplied video cable to the RCA video output connector in the

camera body so that the video image can be seen on a monitor.

While viewing the video on the monitor, adjust horizontally and vertically the

camera pan and tilt. Adjust the lens focus to get optimal video effect.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 65 66

Sin comentarios

UTC TruVision IP Dome Manual de usuario Pagina 14