UTC TruVision IP Dome Manual de usuario descargar pdf (Pagina 16)

1BChapter 2: Installation

12 TruVision IP Dome Open-Standards User Manual

3. Pull the camera’s cabling through the ceiling hole and connect to the devices

and power.

If needed, seal all mounting holes so that no moisture can leak into the

mounting surface.

4. Adjust the camera’s angle of view while watching the image on a monitor.

Loosen the lens positioning screws (1).

Using the supplied hex wrench, adjust the

camera pan and tilt horizontally and

vertically.

Tighten the lens positioning screws.

Note: The lens focus has been adjusted in the factory so should not require

further adjusting.

5. Reattach the camera housing and tighten the fixed screws and. Ensure that

the camera is firmly attached to the ceiling.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 65 66

Sin comentarios

UTC TruVision IP Dome Manual de usuario Pagina 16